Recall 12V001000: 2012 Mitsubishi Outlander Sport

Updated from NHTSA data · How we count

Report date
Jan 3, 2012
Vehicles affected
21
Models
1
Initiated by
Manufacturer

The problem

Mitsubishi is recalling certain model year 2012 outlander sport vehicles, manufactured from november 9, 2011, through december 16, 2011. These vehicles fail to comply with the requirements of federal motor vehicle safety standard no. 108, "lamps, reflective devices, and associated equipment." the turn signal levers in the vehicle were not manufactured correctly, which could result in the auto-cancel function of the turn signal becoming inoperative.

The risk

The turn signal may continue to signal an intended directional change after a point when the auto-cancel function, if operating properly, would have terminated the signal. A following or oncoming driver may receive inaccurate indications of the vehicle operator's intended maneuvers, thereby increasing the risk of a crash between vehicles due to improper vehicle signaling.

The fix

Dealers will inspect the turn signal lever and replace it with a new one free of charge. No vehicles have been retailed to customers with this potential condition, no recall bulletin or owner letters will be prepared. You may contact mitsubishi at 1-800-222-0037.

Notes

Owners may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to <a href=http://www.safercar.gov>http://www.safercar.gov</a> .

Affected vehicles

Details

NHTSA campaign
12V001000
Manufacturer
MITSUBISHI MOTORS NORTH AMERICA, INC.
Owner letters
Jan 9, 2012
Components
Exterior lighting:turn signal (Lighting)

Recall repairs are free at authorized dealers. To see if your vehicle is included, enter your VIN at NHTSA.gov or call the manufacturer.

Source: U.S. National Highway Traffic Safety Administration (NHTSA) Office of Defects Investigation public data. Complaints are submitted by owners and are not verified by NHTSA or by us; a complaint does not prove a defect exists. Methodology