Recall 12V021000: 2009–2011 Morgan Olson Walk IN Van
Updated from NHTSA data · How we count
- Report date
- Jan 19, 2012
- Vehicles affected
- 7,853
- Models
- 1
- Initiated by
- Manufacturer
The problem
Morgan Olson is recalling certain model year 2009-2011 walk-in van type vehicles with a gross vehicle weight rating in excess of 4,536kg (10,000lbs), manufactured from September 1, 2009, through January 19, 2012, with sliding front doors. These vehicles do not have either a primary door latch system, or a door closure warning system. Therefore, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard No. 206, "Door Locks and Door Retention Components."
The risk
Without either a primary door latch system or a door latch system with a fully latched position and a door closure warning system as required by FMVSS 206, the door could partially open without warning and the driver may not be aware that the door is not fully latched, putting the driver at an increased risk of injuries in the event of a crash.
The fix
Morgan Olson will notify owners, and dealers will repair the vehicles free of charge. The safety recall began on April 25, 2012. Owners may contact Morgan Olson at 1-269-659-0200.
Notes
Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.
Affected vehicles
- 2009 Morgan Olson Walk IN Van
- 2010 Morgan Olson Walk IN Van
- 2011 Morgan Olson Walk IN Van
Details
- NHTSA campaign
- 12V021000
- Manufacturer
- MORGAN OLSON CORPORATION
- Owner letters
- Apr 25, 2012
- Components
- Latches/locks/linkages:doors:latch (Body & Structure)
Recall repairs are free at authorized dealers. To see if your vehicle is included, enter your VIN at NHTSA.gov or call the manufacturer.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) Office of Defects Investigation public data. Complaints are submitted by owners and are not verified by NHTSA or by us; a complaint does not prove a defect exists. Methodology