Recall 19V712000: 2014–2020 Thomas Built Buses Minotour, 2014–2020 Thomas Built Buses Saf-T-Liner C2, 2014–2020 Thomas Built Buses Saf-T-Liner EFX +1 more

Updated from NHTSA data · How we count

Report date
Oct 4, 2019
Vehicles affected
53,528
Models
4
Initiated by
Manufacturer

The problem

Daimler Trucks North America LLC (DTNA) is recalling certain 2014-2020 Thomas Built Saf-T-Liner EFX, Minotour, Saf-T-Liner C2, and Saf-T-Liner HDX school buses equipped with SynTec S3B or S3C seats. The seats may have been manufactured with styrene blocks that may not provide sufficient impact absorption in certain specific areas around the steel seat frame of the back support. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 222, "School Bus Passenger Seating and Crash Protection."

The risk

The lack of impact absorption increases the risk of injury in the event of a crash.

The fix

DTNA will notify owners, and dealers will install additional impact material between the re-bond back and the vinyl back cover to increase the amount of absorption, free of charge. DTNA issued owners an interim notification on November 29, 2019. The recall began June 22, 2020. Owners may contact DTNA customer service at 1-800-547-0712. DTNA's number for this recall is FL-832.

Notes

Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.

Affected vehicles

Details

NHTSA campaign
19V712000
Manufacturer campaign
FL-832
Manufacturer
Daimler Trucks North America LLC
Owner letters
Jun 22, 2020
Components
Seats (Seats & Seat Belts)

Recall repairs are free at authorized dealers. To see if your vehicle is included, enter your VIN at NHTSA.gov or call the manufacturer.

Source: U.S. National Highway Traffic Safety Administration (NHTSA) Office of Defects Investigation public data. Complaints are submitted by owners and are not verified by NHTSA or by us; a complaint does not prove a defect exists. Methodology