2008 Ford Fusion brakes problems

Related recalls

• Recall 19V904000Dec 18, 2019600,166 vehicles
  SERVICE BRAKES, HYDRAULIC:ANTILOCK/TRACTION CONTROL/ELECTRONIC LIMITED SLIP:CONTROL UNIT/MODULE

  Ford Motor Company (Ford) is recalling certain 2006-2010 Ford Fusion, Mercury Milan, Lincoln Zephyr and MKZ vehicles. The valves within the ABS Hydraulic Control Units (HCU) may react with brake fluids containing specific corrosion preventative additives. This reaction may cause the valves to not close properly.

  Risk: If the valves do not properly close, additional brake pedal travel may be required to stop the vehicle, increasing the risk of a crash.

  Remedy: Ford will notify owners, and dealers will flush the brake system with DOT 4 fluid and install a new brake fluid reservoir cap. In addition, the HCU will be tested to detect a possible stuck valve condition, replacing the HCU as necessary. All services will be performed free of charge. The recall began April 1, 2021. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 19S54.

What owners say

1. Filed Jul 21, 2026NJBrakes

   I had the Ford brake recall work completed in 2023, but the same brake issue has returned. This appears to be the same HCU problem covered by the recall, and Ford is now refusing to repair it. I am concerned because this is a serious safety issue, and the recall repair did not permanently correct the problem.

   NHTSA complaint #11751872 · source
2. Filed Aug 30, 2025NCBrakes

   I have been having issues with my 2008 ford fusion. I did research and found that the is a Ford customer satisfaction program( campaign # 21N11) which also goes along with recall number 19S54 and ford is refusing to fix the issues. Their lots of complaints and somethingd needs to be done ASAP before someone gets hurt cause this has to do with the brakes.

   NHTSA complaint #11684088 · source
3. Filed Jul 5, 2025KSBrakes

   My brake pedal drops to the floor when braking at times. Mechanics say that is my ABS module. I believe this is a very common issue with these vehicles. This has happened to me several times. Only remedy without repair is disengaging the ABS system all together. There has not been a recall on this but there has been a customer satisfaction program associated with the brake system. I tried to have mine fixed and Ford says the program has expired. I feel like braking is the…

   NHTSA complaint #11671375 · source
4. Filed Feb 8, 2025ILBrakes

   Have to press down hard on brakes to slow or stop. Had landmark ford inspect recall issue & they stated nothing was wrong with brakes.

   NHTSA complaint #11641534 · source
5. Filed Oct 21, 2024CABrakes

   took in for two recalls to Serramonte ford, airbag recall fixed, braking issue not fixed due to as dealer put it, issues with computer system and was not given a timeframe to have it completed, vehicle was returned to me.

   NHTSA complaint #11621078 · source
6. Filed Sep 27, 2024TXBrakes

   The vehicle brakes will engage at random intervals without the brake pedal being touched. This happens at all speeds, and even at a stop. Issue still occurs daily, and has been ongoing for 5+ years. Brake master cylinder and aux boost pump have been replaced twice with OEM parts, and three complete brake jobs (pads, calipers and rotors) in the last 5 years. At slower speeds, it manifests as a drag to forward motion. At higher speeds, the drag is more pronounced, and causes…

   NHTSA complaint #11616815 · source
7. Filed Jan 17, 202479,259 miMOBrakes

   The contact owns a 2008 Ford Fusion. The contact stated that while his girlfriend was driving at undisclosed speeds, the vehicle hydroplaned, and the anti-lock brakes engaged and disengaged. The brake pedal became inoperable. The vehicle was taken to the local dealer, where it was determined that the vehicle had passed testing. The vehicle was repaired, but the failure recurred. While driving the vehicle, the brake pedal was squishy and would depress to the floorboard. The…

   NHTSA complaint #11565926 · source
8. Filed Jun 28, 2023GABrakesDriver Assistance & Safety TechOther / Unknown

   I just bought this car and the brakes do not feel right when i go to stop. They are new and i got them changed today and it still makes a pop noise.

   NHTSA complaint #11529277 · source
9. Filed Mar 11, 2023TNBrakes

   Driving around 55 and put brakes on and went 3/4 to floor like they were out. 2 other people experienced the same. HCA Unit must be bad or corrosive. I read online about this. Ford has extended warranty recall and sent letter and fluid changed 14 yes later. We'll that's a little late cause obviously unit bad now. Ford dealer will not replace cause can't duplicate problem. If I wreck, Ford is liable for 4 to 5 people in car. Common sense would be REPLACE PART!!!

   NHTSA complaint #11511375 · source
10. Filed Mar 8, 202373,000 miTNBrakes

    The contact owns a 2008 Ford Fusion. The contact stated while driving 50 MPH, the brake pedal was depressed and went to the floorboard. The contact was unsure if a warning light was illuminated. The contact pumped the brake pedal several times, and the brake pedal started operating normally. The vehicle was taken to the dealer for diagnostic test; however, the dealer stated that no failure was found. The manufacturer was contacted but offered no assistance. The failure…

    NHTSA complaint #11510773 · source
11. Filed Feb 21, 2023TNBrakes

    The contact owns a 2008 Ford Fusion. The contact received notification of NHTSA Campaign Number: 19V904000 (Service Brakes, Hydraulic) however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.

    NHTSA complaint #11508307 · source
12. Filed Dec 29, 2022151,000 miOHBrakes

    The contact owns a 2008 Ford Fusion. The contact stated while driving at an undisclosed speed, the vehicle drove over a bump in the roadway and the contact depressed the brake pedal however, the vehicle failed to stop immediately. The contact depressed the brake pedal to the floorboard, and the vehicle came to a complete stop. No warning lights were illuminated. The vehicle was taken to a local dealer; however, the dealer was unable to duplicate the failure. The vehicle was…

    NHTSA complaint #11499416 · source

Source: U.S. National Highway Traffic Safety Administration (NHTSA) Office of Defects Investigation public data. Complaints are submitted by owners and are not verified by NHTSA or by us; a complaint does not prove a defect exists. View this vehicle on NHTSA.gov Methodology