2010 Mercury Milan brakes problems

Related recalls

• Recall 19V904000Dec 18, 2019600,166 vehicles
  SERVICE BRAKES, HYDRAULIC:ANTILOCK/TRACTION CONTROL/ELECTRONIC LIMITED SLIP:CONTROL UNIT/MODULE

  Ford Motor Company (Ford) is recalling certain 2006-2010 Ford Fusion, Mercury Milan, Lincoln Zephyr and MKZ vehicles. The valves within the ABS Hydraulic Control Units (HCU) may react with brake fluids containing specific corrosion preventative additives. This reaction may cause the valves to not close properly.

  Risk: If the valves do not properly close, additional brake pedal travel may be required to stop the vehicle, increasing the risk of a crash.

  Remedy: Ford will notify owners, and dealers will flush the brake system with DOT 4 fluid and install a new brake fluid reservoir cap. In addition, the HCU will be tested to detect a possible stuck valve condition, replacing the HCU as necessary. All services will be performed free of charge. The recall began April 1, 2021. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 19S54.

What owners say

1. Filed Sep 24, 2025WABrakes

   The safety recall 19S54 is affecting my vehicle. It was made at the same plant at the approved date range as the other vehicles on the recall list but it seems my vehicle wasnt added to the list because it is a hybrid but it has the same exact issue as the non hybrid models

   NHTSA complaint #11689311 · source
2. Filed Jul 7, 2025140,000 miTNBrakes

   The contact owns a 2010 Mercury Milan. The contact stated that while depressing the brake pedal to the floorboard, the vehicle failed to immediately stop. The vehicle was taken to the local brake service center, but the cause of the failure was not yet determined, and the vehicle was not yet repaired. The manufacturer was notified of the failure, but no assistance was offered. The contact was informed that the VIN was not included in the NHTSA Campaign Number: 19V904000…

   NHTSA complaint #11671729 · source
3. Filed Jan 28, 2025MIBrakes

   Whenever the car engine isn't warm and I slam on the brakes, they barely respond. I have replaced the master cylinder, abs hydraulic module, brake booster, calipers, pads, and rotors, and it still has about 20% normal braking power when the engine is cold. Just got it back from the dealership again. Dealer said no vacuum leak found, no leaks found, abs module checks out fine, and said the check valve passed diagnostics. The problem remains. This has been ongoing for several…

   NHTSA complaint #11639152 · source
4. Filed Oct 28, 2024240,000 miOHBrakes

   The contact owns a 2010 Mercury Milan. The contact stated that while operating the vehicle, the "Check Brake System" and "Service Advance Track" messages remained displayed. The cause of the failure was not yet determined. The contact indicated that the failure had occurred days after the vehicle was repaired under NHTSA Campaign Number: 19V904000 (SERVICE BRAKES, HYDRAULIC). The manufacturer and local dealer were notified of the failure. The failure mileage was 240,000.

   NHTSA complaint #11622282 · source
5. Filed Jul 9, 2024NYCrashBrakes

   My name is [XXX] and I own a 2010 Mercury Milan. I bought it on [XXX] from an 84 year old woman who take good care of it. It had 91,000 miles which were mostly hwy miles. She kept records of all her oil changes. After having it for almost 3 years and keeping up with it myself, on February 27,2024 in the morning I put brake fluid in the car. I had brake pads and rotors done on the car in August 2023. On the evening of [XXX], my son and I took a ride to the local 7/11 which is…

   NHTSA complaint #11600649 · source
6. Filed May 23, 2024WABrakes

   On May 10, 2024, as I was rounding a sharp curve, I applied brakes to slow down, but there were no brakes. In fact the brake pedal went to the floor. I had to use emergency brake to stop and gain my wits. I turned around and slowly drove home (about 0.5 miles) and used e-brake to stop and park in front of house. On May 21 I had vehicle towed to dealer. They found that the brake pedal was still against floorboard, but when they started vehicle, it came back up to normal…

   NHTSA complaint #11590317 · source
7. Filed Apr 11, 202460,539 miNYTowedBrakes

   The contact owns a 2010 Mercury Milan Hybrid. The contact stated while his mother was driving approximately 30 MPH, the brake pedal was depressed and the pedal extended to the floorboard however, the vehicle did not immediately stop. During the failure, the ABS, traction control, and brake warning lights were illuminated. The vehicle was later towed to the local dealer who diagnosed that the HCU and ABS modules were faulty and needed to be replaced. The vehicle was not yet…

   NHTSA complaint #11582395 · source
8. Filed Jun 19, 2023TXBrakes

   Power brake failure, brake pedal goes to the floor, vehicle rolls forward and backward while in park, ABS warning and Trac system warning lights are on and also Brake Service warning light.

   NHTSA complaint #11527715 · source
9. Filed Apr 15, 2023OHBrakes

   The brake system went completely out. The brake pedal has no pressure and goes all the way to the floor. When looking online there are 197 complaints after reading through the first 9D all of them were about the ABS control module. All other repairs regarding to the brakes have already been made with the problem still not being fixed. there were no warning signs of this happening. The brake switch just went out when driving home one day. This has all been diagnosed by a…

   NHTSA complaint #11517196 · source
10. Filed Feb 21, 2023KYBrakesDriver Assistance & Safety Tech

    When starting to drive 2 days ago multiple braking warnings went off on the vehicle, including Advance Trac warnings. The vehicle became extremely difficult to stop, requiring high pressure on the pedal. It was able to be stopped safely as there was an empty parking lot nearby. It was taken to a Ford Dealership (Tri-County Ford) and diagnosed with a failure of the ABS Control Module. The part was confirmed by the dealer to be the same as in NHTSA recall # 19V904000 (Ford…

    NHTSA complaint #11508394 · source
11. Filed Dec 1, 2022165,900 miWIBrakes

    The contact owns a 2010 Mercury Milan. The contact stated while driving at various speeds and depressing the brake pedal, the brake pedal only responded after being depressed further down to the floorboard. There was no warning light illuminated. The vehicle was taken to the used car dealer where the brake line was bled; however, the failure persisted. The dealer was not notified of the failure. The vehicle was not diagnosed or repaired. The manufacturer was notified of the…

    NHTSA complaint #11495591 · source
12. Filed Oct 9, 2022GABrakes

    So my ABS and Traction control lights came on while driving, my steering wheel became stiff, and I had ZERO brakes. I almost hit another vehicle. After being able to pull over and safely park without hurting myself and child or anyone else, I had my husband come get my car. He said that when opening the break fluid cap it was sucked down. It "fixed" itself after the cap was fixed. After a few weeks, my 16 yr old was driving and it happened to her, she pulled over, called me.…

    NHTSA complaint #11488510 · source

Source: U.S. National Highway Traffic Safety Administration (NHTSA) Office of Defects Investigation public data. Complaints are submitted by owners and are not verified by NHTSA or by us; a complaint does not prove a defect exists. View this vehicle on NHTSA.gov Methodology